Logo
  • Products
  • Software
  • Support
  • Resources
  • How to Buy
  • My Neets
  1. Neets Knowledge Base
  2. Switching Relays
  3. Switching Relay - 4

Switching Relay - 4

Follow New articles New articles and comments
  • How do I control the Neets Switching Relay - 4?
  • Can the Neets Switching Relay - 4 or 8 be controlled via LAN?
  • How can I use the Neets Switching Relay - 4 or 8 out of the box?
  • How do I easily adjust the end stops for the screen?
  • How does RS-232 loop-through work on Switching Relay 4 or 8?
  • How to prepare a Neets switching relay for third party control
  • If I want to connect the switching relay 4 or 8 directly to my control system, what type of cable should I use?
  • How do I factory reset a Neets Switching Relay - 4?
  • How to connect relay 3 and 4 on SR-4 with mutual blockage
  • What is the default LAN settings of an Switching Relay - 4 or 8?
  • How can I tell the UNIT ID of a given Neets Switching Relay – 4 or 8?
  • Can I daisy chain Neets Switching Relay - 4 or 8 using RS-232 loop through?
  • How do I set the IP address for Neets Switching Relay - 4 or 8?
  • What is the default Baudrate of a Switching Relay 4 or 8?
  • How can I tell if the Switching Relay 4 is the new improved version?
  • How do I update the firmware if the firmware is 3.6.2 or older? (Only relevant for products bought before August 2015)
  • How do I update the firmware of Switching Relay - 4, if the firmware is newer than 3.6.3?
  • Does the Neets Switching Relay - 4 protect the screen from the possibility of getting mains on both sides of the engine at the same time? (Mutual blocking)
  • Controlling Switching Relay-4 and 8 from a third party controller
© 2018 Neets Knowledge Base