Switching Relays
-
Switching Relay - 1
-
Switching Relay - 2
-
How do I control the Neets Switching Relay - 2?
-
How to add a Neets Switching Relay - 2 to your project
-
How do I easily adjust the end stops for the screen?
-
What is the junction connector in the Switching Relay - 1 and 2 for?
-
What is the internal power supply for?
-
Does the Neets Switching Relay - 2 protect the screen from the possibility of getting mains on both sides of the engine at the same time? (mutual blocking)
-
Why are there odd cut-outs in the printed circuit board?
-
How do I control the Neets Switching Relay - 2?
-
Switching Relay - 4
-
How do I control the Neets Switching Relay - 4?
-
Can the Neets Switching Relay - 4 or 8 be controlled via LAN?
-
How can I use the Neets Switching Relay - 4 or 8 out of the box?
-
How do I easily adjust the end stops for the screen?
-
How does RS-232 loop-through work on Switching Relay 4 or 8?
-
How to prepare a Neets switching relay for third party control
-
If I want to connect the switching relay 4 or 8 directly to my control system, what type of cable should I use?
-
How do I factory reset a Neets Switching Relay - 4?
-
How to connect relay 3 and 4 on SR-4 with mutual blockage
-
What is the default LAN settings of an Switching Relay - 4 or 8?
-
How can I tell the UNIT ID of a given Neets Switching Relay – 4 or 8?
-
Can I daisy chain Neets Switching Relay - 4 or 8 using RS-232 loop through?
-
How to enable PUSH mode for Input state changes on Neets Switching Relays
-
How do I set the IP address for Neets Switching Relay - 4 or 8?
-
What is the default Baudrate of a Switching Relay 4 or 8?
-
How can I tell if the Switching Relay 4 is the new improved version?
-
How do I update the firmware if the firmware is 3.6.2 or older? (Only relevant for products bought before August 2015)
-
How do I update the firmware of Switching Relay - 4, if the firmware is newer than 3.6.3?
-
Does the Neets Switching Relay - 4 protect the screen from the possibility of getting mains on both sides of the engine at the same time? (Mutual blocking)
-
Controlling Switching Relay-4 and 8 from a third party controller
-
How do I control the Neets Switching Relay - 4?
-
Switching Relay - 8
-
How to configure Neets Switching Relay - 4 or 8 for third party control
-
How to enable PUSH mode for Input state changes on Neets Switching Relays
-
How do I secure heavy duty cables?
-
How do I factory reset a Neets Switching Relay - 8?
-
How can I tell if the Switching Relay 8 is the new and improved version?
-
How to configure Neets Switching Relay - 4 or 8 for third party control
-
Neets Switching Relays in general