Knowledge Base
Search and find technical support

Getting started with the Biamp Touch Panels, Apprimo 4, 7 & 10 inch

When you have purchased a Biamp Touch Panel and you have uploaded the graphical interface into the control system, it is now time to set it up.

In this video you can see the different steps how to get started.

 

Basically, you will need to understand that the control systems have a given IP address, which you can alter in Project Designer on the Systems page.

This IP address is what the Touch Panel needs to point to in order to load the user interface from the controller.

On top of that you also need to get the Touch Panel within the range of the control system, so if the controller have IP: 192.168.10.50, you will need to get the Touch Panel in the same range, for example 192.168.10.52.

Was this article helpful?
1 out of 3 found this helpful