Knowledge Base
Search and find technical support

Using UniForm as a keypad for a 3rd party control system

In some cases, you might need to use another control system, but you would still like to keep the look and feel of the Neets keypads. For that reason we have created this article to help you get started using a UniForm as a User Interface for a 3rd party control system like Crestron, AMX, Control4 etc. 

In the below video see how easy it is to get started. 

 

Procedure:

Below you will see an example interface, but this can of course be fully customized in Project Designer with custom coorporate identity and the controls needed for the room. 

On the below image we are also listing the button id numbers that are needed for the protocol below. 

Udklip.PNG

In the attached project you should edit the IP settings as well as the Interface design to match your project. Once the project has been edited and uploaded to the Neets UniForm, your control system can connect to the UniForm.

Start by making a TCP connection to the Neets Control system using port 3000.

 

Button Press Events

When the keys on the Neets UniForm is pressed and released, the below commands will be sent from the UniForm:

KeyDown(X)<CR>   (X are the button id number of the button)

KeyUp(X)<CR>        (X are the button id number of the button)

 

Controlling UniForm LED feedback from the control system,

LED control (On/Off/Blink):

Led(X,Y)<CR>               (X are button id number) Y= On, Off or 1Hz

 

Color control:

Color(X,Y)<CR>            (X are button id number) Y= White, Purple, Turquoise, Yellow, Blue, Red, Green

 

 

Was this article helpful?
0 out of 0 found this helpful