Knowledge Base
Search and find technical support

Is it necessary to connect 24 VDC to the amplifier in order to configure it?

No, configuration can be done at your desk, with only a USB cable connected to the front USB.

Remember on the AMP-D225H, the amplification circuitry is inactive when you only supply it with USB power. 

 

Open a browser and enter http://192.168.0.4 in the address field.

 

If it doesn't load the configuration page, check the steps in this article:

Not able to access website via USB on amplifiers and control systems with GUI

Was this article helpful?
0 out of 0 found this helpful