Knowledge Base
Search and find technical support

Preamplifier - Update firmware

Before installation it is important to update the firmware. This is done through the CONFIG usb port on the front with an open session of Project Designer.

This will automatically check for latest firmware and update if needed.

Biamp_-_Preamp_PM4100_-_Front.png

This window will pop up when you connect your USB cable, then go through the steps by pressing "Yes" and "Start" and the update process will start.

Preamplifier_-_Update_firmware_1.png

 

 

Once the process is done, you'll get a confirmation and your amplifier is up to date.

Preamplifier_-_Update_firmware_2.png

 

Was this article helpful?
0 out of 2 found this helpful