Knowledge Base
Search and find technical support

Language error after upload to Project Designer 1.25.0

Error during upload after updating to Project Designer 1.25

Feb 6th, 2020: We are working hard on a fix and will release a bug fix very soon!

If you experience that you get an error during upload to a control system and it says something about the language, then do the following: 

 

For now, the fix is simple, just do these steps:

In Interface, select the Design tab and select the Language “From Project”

 mceclip1.png

Then go to the bottom and maybe the two last lines are empty, but either way, change the text to something else, or just retype the text in the two boxes!mceclip0.png

That’s it ;-) Press OK and you are ready to upload again! 

Was this article helpful?
1 out of 1 found this helpful