Knowledge Base
Search and find technical support

How to prepare a switching relay for 3rd party control

Attached in this article, you will find a Docklight driver we have created for this purpose. In this driver, you will find the commands necessary to setup your Switching relay product.

When you have downloaded the driver you have three ways to connect to your Switching relay box.

- RS-232 (Baudrate 19200,8,1,N, remember to cross Rx/Tx)

- LAN (default IP: 192.168.254.252, TCP port 5000)

- USB cable to your switching relay product and find the COM port in Docklight. Open the connection and start your configuration.

When using the USB connection it is important that you dont have Biamp Project Designer running.

 

in this video you can see how to to set IP, Gateway, Baud rate etc.

 

Was this article helpful?
0 out of 0 found this helpful