Knowledge Base
Search and find technical support

How to prepare a Neets switching relay for third party control

On the Neets website you can find a Docklight driver we have created for this purpose. In this driver you will find the commands nesecary to setup your Neets Switching realy product.

Simply connect the USB cable to your switching relay product and find the COM port in Docklight. Open the connection and start your configuration.

IMPORTANT: Neets Project Designer must be closed when this operation are done.

in this video you can see how easy it is to set IP, Gateway, Baud rate etc. 

 

 

Was this article helpful?
0 out of 0 found this helpful