Knowledge Base
Search and find technical support

Using an input for a movement sensor (PIR)

How to use an input for a movement sensor

You are able to use one of the inputs on any of the Neets controllers to trigger any action from the activity of the movement sensor.

The Bosch movement sensor sold by Neets is a Normally Closed version meaning that when activity is detected, the contacts are opened.

So in Neets Project Designer you should remember to set the "Movement when" to HIGH

Below is a diagram that shows the wiring to make it work with our PIR sensor.

 

First, you start in System and insert a Movement sensor (PIR) from the Neets->Digital inputs/Outputs category.

 

mceclip0.png

 

Then you go to Feedback and define the actions you will need the controller to perform, when either deteting movement or as often used when no movement is detected for an amount of time!

Use the "Press button" action to press the power off for example.

 

Was this article helpful?
0 out of 0 found this helpful