Knowledge Base
Search and find technical support

RS-232 Settings

Communication parameters

Select the baud rate, number of data bits, parity and number of stop bits the device is using.

Byte delay

If you need a delay between each byte sent on the com port you can specify that here. This setting will take effect for all commands. If you need the delay for only one sequence you can specify it there.
Please note that the byte delay is only accessible from device version 2.00.

Feedback

If your device is 2.20 or above it supports feedback. You can then enter a delay between any feedback request is sent. If the device you are controlling isn't capable of handling many requests, you can adjust this value. Please note that this is a minimum value.

From version 2.30 it is also possible to use a separator for incoming feedback. This or these character(s) should be specified in cases where feedback is grouped in the same message. For example:
Power=On<CR>Source=HDMI<CR>
In this case Power=On<CR> and Source=HDMI<CR> will be handled as separate replies.

Was this article helpful?
0 out of 0 found this helpful