Note: This is only necessary if you are using a third party controller other than Neets.
This is done with the RS-232 on port 1 by sending the following command:
NEUNIT=1,SETTINGS=LAN,IPADDRESS=192.168.1.100<CR> where the UNIT ID of your relay is 1, and 192.168.1.100 is the IP address you want to set.
Remember to send a save command to save your settings for when the power is off.
The save command is: NEUNIT=1,SAVE=TRUE<CR>
See the protocol list in the manual for further network settings you can alter.
<CR> means Carriage Return in Hex=0D